地图 - 热线
- 服务热线 - 15392885678 15069779222
废水处理设备的选型,从来不是“越贵越好”或“越先进越好”,而是“越合适越好”。一套设计合理的废水处理系统,需要在达标排放的前提下,兼顾建设成本和运行费用。那么,如何判断哪种工艺适合自己的项目?以下七个维度是关键。
The selection of wastewater treatment equipment is never "the more expensive the better" or "the more advanced the better", but "the more suitable the better". A well-designed wastewater treatment system needs to balance construction and operational costs while meeting discharge standards. So, how to determine which process is suitable for your project? The following seven dimensions are key.
第一,看废水水质。 生活污水水质相对稳定,常规的酸化、好氧生物处理即可满足要求。而工业废水则需要根据具体水质选择工艺,非常要注意废水的可生化性——通常要求COD/BOD?≥0.3,如不能满足,需考虑厌氧水解酸化提高可生化性,或采用物理化学方法处理。
Firstly, check the quality of the wastewater. The quality of domestic sewage is relatively stable, and conventional acidification and aerobic biological treatment can meet the requirements. Industrial wastewater requires the selection of processes based on specific water quality, with particular attention paid to the biodegradability of the wastewater - typically requiring COD/BOD? If it cannot meet the requirement of ≥ 0.3, anaerobic hydrolysis acidification should be considered to improve biodegradability, or physical and chemical methods should be used for treatment.
第二,看处理程度要求。 这是工艺流程选择的主要依据,取决于处理后水的去向和所流入水体的自净能力。目前主要依据《污水综合排放标准》及相关行业排放标准来确定。

Secondly, it depends on the level of processing required. This is the main basis for selecting the process flow, which depends on the destination of the treated water and the self purification capacity of the incoming water body. At present, it is mainly determined based on the Comprehensive Wastewater Discharge Standards and related industry discharge standards.
第三,看建设及运行费用。 在处理水达到水质标准的前提下,应优先考虑工程建设及运行费用低的工艺流程。减少占地面积也是降低建设费用的重要措施。
Thirdly, consider the construction and operational costs. Under the premise of treating water to meet water quality standards, priority should be given to process flows with low engineering construction and operating costs. Reducing the footprint is also an important measure to lower construction costs.
第四,看施工难易程度。 地下水位高、地质条件差的地方,不适宜选用深度大、施工难度高的处理构筑物。
Fourth, assess the level of difficulty in construction. Places with high groundwater levels and poor geological conditions are not suitable for using deep and difficult construction structures for treatment.
第五,看当地自然和社会条件。 气候寒冷的地区,应采用在低温季节也能正常运行并保证达标水质的工艺。原材料、水资源与电力供应等社会条件也需纳入考量。
Fifth, consider the local natural and social conditions. In areas with cold climates, processes that can operate normally during low temperature seasons and ensure standard water quality should be adopted. Social conditions such as raw materials, water resources, and electricity supply also need to be taken into consideration.
第六,看污水水量。 对于水量、水质变化大的项目,应优先考虑抗冲击负荷能力强的工艺,或设立调节池等缓冲设备。
Sixth, check the amount of sewage. For projects with significant changes in water quantity and quality, priority should be given to processes with strong resistance to impact loads, or the establishment of buffering equipment such as regulating tanks.
第七,看是否产生二次污染。 污水处理过程中应注意是否会造成新的环境问题。例如,含有机物质的废水在曝气过程中会有有机废气排放;某些废水处理中产生的污泥处置也是核心考虑的问题。
Seventh, check if there is any secondary pollution. During the sewage treatment process, attention should be paid to whether it will cause new environmental problems. For example, wastewater containing organic substances will have organic waste gas emissions during the aeration process; The disposal of sludge generated in certain wastewater treatments is also a key consideration.
从设备构成看,一套完整的废水处理系统通常包括前处理设备(拦污栅、沉砂设备、除油设备)、初级处理设备(沉淀池、浮除池)、二级处理设备(生物处理相关设备)、三级与出彩处理设备(除氮除磷、消毒等)以及污泥处理设备。选型时,应根据上述七个维度综合判断,进行多种方案的技术经济比较,才能得出非常优解。
From the perspective of equipment composition, a complete wastewater treatment system usually includes pre-treatment equipment (trash racks, sand settling equipment, oil removal equipment), primary treatment equipment (sedimentation tanks, floating tanks), secondary treatment equipment (biological treatment related equipment), tertiary and advanced treatment equipment (nitrogen and phosphorus removal, disinfection, etc.), and sludge treatment equipment. When selecting, a comprehensive judgment should be made based on the seven dimensions mentioned above, and multiple technical and economic comparisons should be made to obtain the optimal solution.
本文由废水处理设备友情奉献.更多有关的知识请点击:http://www.tdyhhb.com真诚的态度.为您提供为多维度的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.
This article is a friendly contribution from wastewater treatment equipment For more information, please click: http://www.tdyhhb.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.
截屏,微信识别二维码