石转轮+CO 、沸石转轮+RTO 、危废暂存间、催化燃烧设备
地图 - 热线
15392885678

- 服务热线 - 15392885678 15069779222

大风量低浓度废气,别直接烧

发布人:武汉润华环保设备有限公司 发表时间:2026-11-04

喷漆、印刷、涂布线常碰到一个矛盾:风量几万方,浓度却只有几十到几百毫克。直接进焚烧炉,天然气烧到心疼;只靠吸附,饱和太快还产生危废。把“大风量”先缩成“小风量高浓度”,才是这套组合的逻辑起点。

Spray painting, printing, and coating lines often encounter a contradiction: the air volume is tens of thousands of cubic meters, but the concentration is only tens to hundreds of milligrams. Directly entering the incinerator, burning natural gas until heartbroken; Relying solely on adsorption, saturation is too fast and hazardous waste is generated. The logical starting point of this combination is to first reduce "high air volume" to "low air volume and high concentration".

687c7a79-c1a3-43cb-b2da-f8692ecea7a2

工艺链就三步:

The process chain consists of three steps:

预处理:漆雾、粉尘、油雾先过干式过滤(初效+中效,出口颗粒物控到1mg/m³级),水汽高要降温除湿,否则沸石孔道会堵。

Preprocessing: Paint mist, dust, and oil mist are first filtered through dry filtration (initial effect+medium effect, with outlet particulate matter controlled to 1mg/m ³ level). If the water vapor is high, it should be cooled and dehumidified, otherwise the zeolite pores will be blocked.

转轮浓缩:疏水沸石在常温吸附区捕VOCs,转轮慢转;饱和区进180–220℃脱附区,吹出小风量浓气;再经冷却区复位。脱附风量通常取吸附风量的1/10左右,浓缩倍数看工况一般10–15倍。

Wheel concentration: Hydrophobic zeolite captures VOCs in the adsorption zone at room temperature, and the wheel rotates slowly; Enter the desorption zone at 180-220 ℃ in the saturation zone and blow out a small volume of concentrated air; Reset again through the cooling zone. The desorption air volume is usually about 1/10 of the adsorption air volume, and the concentration factor depends on the operating conditions, usually 10-15 times.

RTO销毁:浓气进蓄热炉,750–850℃氧化成CO₂和水,陶瓷蓄热体回收热量,部分余热回给脱附用,热回收率可到90%以上。

RTO destruction: The concentrated gas enters the heat storage furnace and is oxidized to CO ₂ and water at 750-850 ℃. The ceramic heat storage body recovers heat, and some of the waste heat is returned to desorption. The heat recovery rate can reach over 90%.

选型先问六件事:风量、浓度波动、组分(是否含硅/硫/氯/高沸点物)、温湿度、粉尘油雾、日运行小时数。

Six things should be asked before selecting: air volume, concentration fluctuations, composition (whether it contains silicon/sulfur/chlorine/high boiling point substances), temperature and humidity, dust and oil mist, and daily operating hours.

连续两班以上、风量>1万方:转轮+RTO合适;

Continuous two or more shifts, air volume greater than 10000 cubic meters: suitable for rotary wheel+RTO;

每天只开几小时:频繁启停伤蓄热体和密封,中小风量可改活性炭+CO更划算;

Only open for a few hours a day: frequent start stop damage to the heat storage body and seal, using activated carbon+CO for small and medium air volume is more cost-effective;

含硅烷、焦油、树脂雾:不预处理直接进转轮等于慢性报废。

Containing silane, tar, and resin mist: Directly entering the wheel without pre-treatment is equivalent to chronic scrapping.

运维三条红线:

Three red lines for operation and maintenance:

过滤器压差超初始1.5倍就换,别等堵死;

Replace the filter if the pressure difference exceeds 1.5 times the initial value, don't wait for it to clog;

脱附温度别乱加,超220℃加速密封老化、损伤沸石;

Do not add desorption temperature randomly, exceeding 220 ℃ accelerates seal aging and damages zeolite;

高沸点残留每月做一次高温再生(250–300℃短时活化),防孔道累积中毒。

Perform high-temperature regeneration (short-term activation at 250-300 ℃) once a month for high boiling point residues to prevent pore accumulation and poisoning.

安全上,入炉浓度锁在LEL的25%以内,配在线监测、稀释阀、泄爆和熄火保护。

Safely, the furnace concentration is locked within 25% of LEL, equipped with online monitoring, dilution valve, explosion and shutdown protection.

环保设备不是越大越好,算清“浓缩比—热平衡—预处理”这三笔账,运行费才压得下来。

The larger the environmental protection equipment, the better. Only by calculating the three accounts of "concentration ratio thermal balance pretreatment" can the operating costs be reduced.

相关产品
Related products
相关新闻
Related News
Address

地址

武汉市黄陂区汉口北大道21号金马凯旋家居CBD原辅材料市场L02
Contact Us

服务热线

15392885678

15069779222
Mailbox

邮箱

1432716203@qq.com

微信二维码

微信公众号

微信二维码

微信公众号

//

截屏,微信识别二维码