石转轮+CO 、沸石转轮+RTO 、危废暂存间、催化燃烧设备
地图 - 热线
15392885678

- 服务热线 - 15392885678 15069779222

风量巨大、浓度才两百?别硬烧,先“浓缩”再进炉

发布人:武汉润华环保设备有限公司 发表时间:2026-10-21

喷漆房、印刷线、涂装车间非常典型的 VOCs 废气画像:风量 30000~100000 m³/h,浓度 200~300 mg/m³。这种气直接进 RTO,天然气烧得像漏水的水龙头——蓄热体再省热,也架不住“用 800℃ 烤空气”。

The most typical VOCs exhaust gas image in paint spraying rooms, printing lines, and painting workshops: air volume of 30000-100000 m ³/h, concentration of 200-300 mg/m ³. This gas directly enters RTO, and natural gas burns like a leaking faucet - even if the heat storage body saves heat, it cannot withstand "baking air at 800 ℃".

20230919074017718

一、沸石转轮在干啥:把“稀汤”熬成“浓酱”​

1、 What is the zeolite wheel doing: boiling "thin soup" into "thick sauce"

沸石转轮靠疏水沸石蜂窝体做吸附:大风量低浓度废气穿过转轮,VOCs 被沸石孔道抓住,净化后直接排放;转轮慢转(2~6 rpm)到脱附区,用小风量热风(180~220℃)把污染物“洗”下来,出来就是浓度翻 5~20 倍的浓缩气。原来 300 mg/m³、80000 m³/h,脱附后可能变成 4000 mg/m³、6000 m³/h——后续 RTO 处理量直接砍到十分之一。

The zeolite wheel relies on hydrophobic zeolite honeycomb for adsorption: high air volume and low concentration exhaust gas pass through the wheel, and VOCs are captured by the zeolite pores and purified before being directly discharged; Slowly rotate the wheel (2-6 rpm) to the desorption zone, and use low air volume hot air (180-220 ℃) to "wash" the pollutants, resulting in a concentrated gas with a concentration increased by 5-20 times. The original capacity of 300 mg/m ³ and 80000 m ³/h may be reduced to 4000 mg/m ³ and 6000 m ³/h after desorption - the subsequent RTO processing capacity will be directly reduced to one tenth.

二、RTO 接住浓缩气:烧得动、也烧得起​

2、 RTO catches concentrated gas: can burn and ignite

三室/五室蓄热燃烧炉,760~820℃ 把 VOCs 氧化成 CO₂+H₂O,蓄热陶瓷回收 95% 以上热量。进炉浓度够,系统甚至能进入“自维持燃烧”,天然气只用来补热和启炉。搭配余热锅炉/热风回用,烤漆房加热、前处理烘干大多能蹭上这股热。

Three chamber/five chamber regenerative combustion furnace, capable of oxidizing VOCs to CO ₂+H ₂ O at 760-820 ℃, with regenerative ceramics recovering over 95% of the heat. The furnace concentration is sufficient, and the system can even enter "self-sustaining combustion", with natural gas only used for heating and start-up. Paired with a waste heat boiler/hot air reuse, this heat can be absorbed by the baking paint room heating and pre-treatment drying.

三、选型别只问“处理效率 99%”​

3、 Don't just ask about "processing efficiency of 99%" when choosing a model

真要盯的是:

What really needs to be monitored is:

沸石是不是疏水型(含水汽的喷涂废气,亲水沸石半年就堵);

Is zeolite hydrophobic (spraying exhaust gas containing water vapor, hydrophilic zeolite clogs within six months);

转轮风速、厚度、区比(吸附/脱附/冷却)合不合理;

Is the wind speed, thickness, and zone ratio (adsorption/desorption/cooling) of the impeller reasonable;

RTO 有没有 LEI 浓度联锁、吹扫、旁通、防爆阀;

Does RTO have LEI concentration interlock, purge, bypass, and explosion-proof valves;

高沸点组分(如漆雾、硅、蜡)进转轮前有没有除雾/过滤,不然转轮“中毒”不可再生。

Are high boiling point components (such as paint mist, silicon, wax) defogged/filtered before entering the impeller, otherwise the impeller will be "poisoned" and cannot be regenerated.

四、什么场景别用这套​

4、 What scene? Don't use this set

浓度本身就高(>3000 mg/m³)、含卤素/硅氧烷多、或者风量很小单班生产——前者直接 CO/RTO 更省,后者上转轮运维比废气还贵。

The concentration itself is high (>3000 mg/m ³), contains a lot of halogens/siloxanes, or has a small air volume for single shift production - the former is more cost-effective in direct CO/RTO, while the latter is more expensive to operate on a rotating wheel than exhaust gas.

沸石转轮+RTO 的本质,是用“吸附浓缩”把低浓度废气的运行成本打下来,再用“蓄热焚烧”把达标稳定性顶上去。工艺顺序对了,环保达标和燃气账单才不会互相打架。

The essence of zeolite wheel+RTO is to use "adsorption concentration" to reduce the operating cost of low concentration exhaust gas, and then use "thermal storage incineration" to enhance the stability of meeting the standards. If the process sequence is correct, environmental standards and gas bills will not fight each other.

相关产品
Related products
相关新闻
Related News
Address

地址

武汉市黄陂区汉口北大道21号金马凯旋家居CBD原辅材料市场L02
Contact Us

服务热线

15392885678

15069779222
Mailbox

邮箱

1432716203@qq.com

微信二维码

微信公众号

微信二维码

微信公众号

//

截屏,微信识别二维码